Installation Instructions - HAMPTON BAY 131 852 Instruction Manual

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#5)
1 (#8)
Circular Strap

INSTALLATION INSTRUCTIONS:

1. Thread the Mounting Screws (#7) into the pre-drilled holes in the Circular Strap (#8)
spaced the same distance apart as the holes in the Wall Plate (#2).
2. Attach the Circular Strap (#8) to the outlet box (#10) with the two outlet box screws (#6)
as shown. The side of the Circular Strap marked "GND" must face out.
3. Connect the white wire from the fixture to the white wire from the Outlet Box (#10), and
the black wire from the fixture to the black wire from the Outlet Box (#10). Cover the two
wire connections using the two provided Wire Connectors (#9). Wrap the two wire
connections with electrical tape for a more secure connection. If your outlet box has a
ground wire (green or bare copper), connect fixture's ground wire to it using the wire
connector (#9). Otherwise connect the copper ground from the fixture to Ground screw
(#5) on the Circular Strap (#8). Note: If you have electrical questions, consult your local
electrical code for approved grounding methods.
4. Mount the body of the fixture on the wall by aligning the protruding Mounting Screws (#7)
all the way through the holes on the Wall Plate (#2). Be careful not to pinch any of the
wires between the fixture and the Outlet Box (#10). Tighten the fixture to the wall by
screwing the two Cap Nuts (#3) onto the two protruding Mounting Screws (#7).
5. Once the fixture is mounted on the wall, caulk the space between the wall and the upper
3/4 area of the Wall Plate (#2) to prevent water seeping into the Outlet Box (#10). Leave
the bottom 1/4 area un-caulked for drainage of any water which might leak into the
enclosure.
6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
2 Outlet Box Screws (#6)
3 Wire Connectors (#9)
2 Mounting Screws (#7)