Table of Contents
Advertisement
HAZARDS WITH MAINTENANCE OF IMPLEMENT
AVOID DEATH OR SERIOUS INJURY FROM COMPONENT FAILURE BY KEEPING IMPLEMENT IN
GOOD
MAINTENANCE.
BEFORE PERFORMING SERVICE, REPAIRS AND MAINTENANCE ON THE IMPLEMENT:
SECURE EQUIPMENT FOR SERVICE
BLOCK OUT POTENTIAL ENERGY HAZARDS; Rotating Parts, Raised Components, Hydraulic Pressure.
STOP ENGINE
•
, engage parking brake and allow all moving parts to stop and remove key before dismounting from tractor seat.
PLACE
•
implement on ground or securely block up raised equipment. Use large blocks on soft or wet soil.
PUSH
PULL
•
and
Remote Hydraulic Cylinder lever to relieve hydraulic pressure.
•
DISCONNECT IMPLEMENT driveline from tractor PTO Shaft.
WEAR SAFETY GLASSES with side shields (marked with ANSI Z87), PROTECTIVE GLOVES and follow SAFETY
PROCEDURES when performing service, repairs and maintenance on the implement:
WEAR
•
Always
protective
WEAR GLOVES
•
Always
AVOID CONTACT
•
with hot hydraulic oil tanks, pumps, motors, valves and hose connection surfaces.
SECURELY
BLOCK UP
•
support or
STOP
•
any implement movements and
USE
•
ladder or raised stands to reach high equipment areas inaccessible from ground.
ENSURE
•
good footing by standing on solid flat surfaces when getting on implement to perform work.
FOLLOW
•
manufacturer's instructions in handling oils, solvents, cleansers, and other chemical agents.
DO NOT
•
change any factory-set hydraulic calibrations to avoid component or equipment failures.
DO NOT
•
modify or alter implement, functions or components.
DO NOT WELD
•
or repair rotating mower components. These may cause vibrations and component failures being thrown from
mower.
PERFORM SERVICE, REPAIRS, LUBRICATION AND MAINTENANCE OUTLINED IN IMPLEMENT MAINTENANCE
SECTION:
INSPECT
•
for loose fasteners, worn or broken parts, leaky or loose fittings, missing or broken cotter keys and washers on pins, and
all moving parts for wear.
REPLACE
•
any worn or broken parts with authorized service parts.
LUBRICATE
•
unit as specified by lubrication schedule
NEVER
•
lubricate, adjust or remove material while it is running or in motion.
TORQUE
•
all bolts and nuts as specified.
BLADE INSPECTION:
REPLACE
•
bent, damage, cracked or broken blades immediately with new blades.
AVOID
•
blade failures and thrown broken blades.
SAFETY SHIELDS, GUARDS AND SAFETY DEVICES INSPECTION:
KEEP
•
all Deflectors, Chain Guards, Steel Guards, Gearbox Shields, and PTO integral shields, Bands, Side Skirts and Skid Shoes
in place and in good condition.
•
REPLACE any missing, broken or worn safety shields, guards and safety devices.
Cancer and Reproductive Harm www.P65Warnings.ca.gov.nt
TW30 Series 11/19
© 2020 Alamo Group Inc.
SAFETY
OPERATING
CONDITION
GLOVES
when handling chemicals or worn component with sharp edges.
SAFETY GLASSES with side shields (marked with ANSI Z87)
and
raised implement, framework and lifted components before working underneath equipment.
SHUT-OFF TRACTOR
DO NOT
Safety Section 1-14
IN
PERFORMING
PROPER
engine before doing any work procedures.
straighten, weld, or weld hard-facing blades.
SERVICE,
REPAIRS AND
when servicing components
PN HM01
Advertisement
Table of Contents
