Navien NPE-180A2 Installation Manual page 65

4. "SYNC" appears on the LCD display for 5-10
seconds until it syncs with the connected panel
and the main remote controller after the ID is
assigned.
5. When the synchronization completes, identical
information will appear on the displays of the
main and sub controllers.
The two controllers and front panel will be
controlled simultaneously by controlling only
one controller.
4.6.2 Checking the Multi Remote
Controller System Setting
After completing the multi remote controller
setting, you can check the setting by pressing the
OK button and Lock button simultaneously for 2
seconds.
Verify that the setting is successful by confirming
that one controller displays "MAIN" and the other
one displays "SUB. "
2
sec
4.6.3 Initializing the Multi Remote
Controller System Setting
You can initialize the multi remote controller system
when you have to reset or replace the multi remote
controllers. Press the Preheat & Timer button and
Lock button simultaneously for 2 seconds on any of
the controllers.
After initializing the setting, repeat the instructions
from the "4.6.1 Initially Setting the Multi Remote
Controller System" on page 64.
If you initialize only one of the
Note
controllers, the other one is initialized
automatically.
Configuring the Remote Controller System
2
sec
2
sec
65