Table of Contents
Advertisement
Eclipseä 2000
Condensing Section Assembly
(CP2086 to ERC2086):
1. Remove cartons from compressor package and
condenser.
2. Remove top from both units.
3. Remove front panel from CP unit.
4. Locate legs, secured to ERC unit.
5. Locate fasteners, inside junction box of ERC
unit.
Connect
6. Assemble rear legs to ERC using fasteners from
Power
prior step.
Here
Locate
Fastener
Package
Connect
Fan Motor
Leads
7. Locate wire package in CP unit. Remove short
CP Unit Contactor, Three Phase Shown
wires and two wire nuts.
8. Use wire & wire nuts from step 7 to connect to
the wires inside the junction box of the condenser.
Return junction box cover to its original position.
9. Place front of ERC on back flange of CP unit.
10. Secure CP unit to ERC.
11. Attach leg brace between ERC unit and CP
unit.
12. Route wires from condenser through hole in
back of CP unit to the CP unit control box.
13 Pull ERC female refrigerant connections
forward to engage male connections on CP unit.
Rotate Swivel
14. Rotate swivel nuts to tighten refrigerant
Nuts to Connect
connections. Use a back up wrench to hold female
Condenser
connection to prevent tearing of the diaphragms.
System to
Compressor
15. Connect wire to T1 and T2 of the contactor.
Unit
Use the two wire nuts to connect the other end to
the two black wires in the condenser junction box.
16. Return tops to their original positions.
September 2003
Page 16
Advertisement
Table of Contents
