Table of Contents
Advertisement
Eclipseä 2000
Controller Features & Last Error Recall
Last Error/Diagnostic Light Recall
To recall the last error on the blue housing CM
controller:
1. Switch the unit OFF by holding the OFF button
for longer than 3 seconds.
2. Hold the Off button down again until the Purge
Setting indicators (Green Lights) are on.
3. Push and release the Harvest button.
The last error code stored in the controller will be
displayed and the purge setting will disappear.
Push the Harvest button again and the
second-to-last error code will be displayed. The bin
full light will also be on to signal that this is the
second-to-last code.
Pushing the Harvest button again will display the
last error code again. Only two error codes are
available for display.
If no error code exists, no code will be displayed
and there will be NO LIGHTS showing.
To return from the display of the last error, do
nothing for 60 seconds or push and hold the Off
button.
After returning from the display of the last error (Off
light glows), the machine may be returned to the
ice making process by pushing and releasing the
Freeze button.
Controller Diagnostic Codes
If a Diagnostic
Water Light
Light
Blinks once and
Water pump will
repeats
not start
Blinks twice and
Lack of water fill
repeats
Blinks three
not used
times and
repeats
Is ON all the time Water valve
leaking thru
rapidly
Both ON all the
Check for thermistor set unplugged
time
or failed
Program ID
3
The blue housing controller will display a code at
power up that indicates which ice machine model it
has been programmed for.
The code is based on the green lights that are
displayed.
1. At power up all lights flash ON once to indicate
that the controller has passed its internal
self-checks.
2. Immediately after that the program code will be
displayed for 20 seconds or until a button is
pushed.
Note: The proper program code for this machine is
glowing
·
Do NOT operate this machine if the wrong code is
displayed.
3. If no button is pushed after 20 seconds the
machine will display the Off light and is ready for
switch inputs (push and release Freeze to start
making ice).
Note: The Red Diagnostic Lights will be
FLASHING while the program ID is displayed.
Refrigeration
Light
Very long ice
harvest
No harvest of ice
High discharge
temperature
Maximum freeze
time
September 2003
Page 44
CME2086: Bin Full, Freeze and Harvest
Advertisement
Table of Contents
