Sony NXCAM HXR-NX80 Operating Manual page 137

The POWER/CHG lamp flashes while charging the battery pack.
• The battery pack may not be able to be charged if the temperature of the battery pack is too
high or too low.
• Reattach the battery pack correctly.
• If the lamp continues to flash, there may be a problem with the camcorder. Disconnect the
plug from the power outlet, and contact a service representative.
The remaining battery indicator does not indicate the correct figure.
• Ambient temperature is too high or too low, or the battery pack has not been charged enough.
This is not a malfunction.
• Fully charge the battery again. If the problem persists, the battery may be worn-out. Replace
with a new battery (p. 21, 158).
• The indicated figure may not be correct in certain circumstances. For example, when you
open or close the LCD screen, it takes about 1 minute to display the correct remaining
battery.
The battery pack discharges too quickly.
• Ambient temperature is too high or too low, or the battery pack has not been charged enough.
This is not a malfunction.
• Fully charge the battery again. If the problem persists, the battery may be worn-out. Replace
with a new battery (p. 21, 158).
Grid-like points are visible on the panel.
• This is not a malfunction. These points are normal results of the manufacturing process and
do not affect the recording in any way.
The image on the viewfinder is not clear.
• Move the diopter adjustment dial until the image is clear (p. 26).
The touch panel is open, but the LCD screen is not displayed.
• The LCD screen is not displayed if the eye sensor detects something nearby and the
camcorder switches to viewfinder view.
The supplied Wireless Remote Commander does not function.
• Set [REMOTE CONTROL] to [ON] (p. 126).
• Remove any obstructions between the Wireless Remote Commander and the remote sensor
of the camcorder.
• Detach the lens hood (supplied).
• Keep strong light sources, such as sunlight or overhead lighting, away from the remote
sensor, otherwise the Wireless Remote Commander may not function properly.
• Change the battery. Insert a fresh battery with the +/– terminals aligned correctly (p. 16).
137
Continued ,