Table of Contents
Advertisement
Hardware description
Structure > Interfaces
2.3.2 Interfaces
RS232/RS422/RS485
interface (switchable)
12
The Panel PC starts automatically when the power
supply is switched on.
But you can change the configuration in the BIOS
setup so that the Panel PC has to be switched off by
the power switch.
on page 47
After a Windows
switched on again by means of the power switch at any
time.
During operation the Panel PC switches to the sleep
mode by briefly pushing the power switch. By pushing
the power switch again the sleep mode is switched off.
The 9-pin male SubD connector may be switched in the BIOS. Here
also the termination resistor of the RS422 and RS485 interface may
be activated or deactivated.
tion"' on page 44
RS232 interface
n
Logical conditions as voltage level
n
Point-to-point connection with serial full-duplex transfer
n
Data transfer up to a distance of 15m
n
Data transfer rate up to 115.2kbit/s
Ä 'Restore AC Power Loss'
Ò
'Shut down' the Panel PC can be
Ä 'Submenu "Serial Port 1 Configura-
HB160 | PPC | 67K-PNL0 | GB | 16-40
VIPA HMI
Advertisement
Table of Contents
