Advertisement
14 times
APP sensor
error
Paper feed cam
sensor error
15 times
USB host Vbus
overcurrent
16 times
Pump roller
sensor error
17 times
Paper eject
encoder error
19 times
Ink tank
position sensor
error
20 times
Other errors
[6A90]
(5) APP slit film condition:
Clean the APP slit film using lint-free
paper.
(6) APP code wheel gear condition:
If the gear wears, replace the gear.
(7) Cable connection:
- PE sensor cable
- Motor multi harness ass'y
Re-connect the cables.
If any damage or breakage of the
cable is found, replace the cable.
[6B10]
(1) Ink absorber counter value:
If the value exceeds 60%, replace the
ink absorber. Follow the "Guideline
for Preventive Replacement of the Ink
Absorber."
(2) Jammed paper or foreign material in the
under guide:
Remove the jammed paper and
foreign material.
[9000]
(1) Part replacement:
Replace the logic board ass'y.
[5C20]
(1) Cable connection:
- Valve cam harness (CN700)
Re-connect the cable.
[6010]
(1) Smearing on the LF / EJ slit film:
Clean the LF / EJ slit film using lint-
free paper.
(2) Foreign material in the paper path:
Remove foreign material.
(3) Cable connection:
- LF encoder cable
- PE sensor cable
Re-connect the cable.
If any damage or breakage of the
cable is found, replace the cable.
(4) Scratches on the LF / EJ slit film:
Replace the timing slit disk feed film
or the timing slit disk eject film.
[6502]
(1) Ink tank position:
Confirm the ink tank position.
(2) Re-set or replacement of ink tanks:
If the error persists, replace the ink
tanks.
(3) Cable connection:
- Ink absorber multi harness (CN701)
Re-connect the cable.
[6500]
(1) Cable connection:
11 / 66
- Pick-up arm
unit
- Duplex paper
feed roller unit
- Purge drive
system unit
- Timing sensor
unit
- Platen unit
- Logic board
ass'y
- Paper feed
motor
- Spur unit
- Logic board
ass'y
- Logic board
Advertisement
