Table of Contents
Advertisement
Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface (Figure S.1).
4. Place one hand around the base and one hand on the Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the arrows
(Figure S.1).
5. Lift up the stand to unhook it from the monitor (Figure S.1).
The monitor can now be mounted using an alternate method.
Reverse process to reattach stand.
NOTE:
Handle with care when removing monitor stand.
Flexible Arm Installation
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how Remove Monitor Stand for
Mounting to remove the stand.
2. Using the 4 screws from the stand removal and attach the arm to
the monitor (Figure F.1).
Caution: Use ONLY the screws (4 pcs) that are included or the
screws M4 size (Length: thickness of bracket and washer +
10-12 mm) when mounting to avoid damage to the monitor
and stand. To fulfi l the safety requirements the monitor
must be mounted to an arm which guaranties the
necessary stability under consideration of the weight of
the monitor. The LCD monitor should only be used with
an approved arm (e.g. GS mark).
Unit
10-12 mm
Thickness
of bracket
and washer
NOTE:
Tighten all screws.
(recommended Fasten Force: 98 - 137N•cm)
*2 MDview 271 only.
Mounting
Bracket
Washer
Screw
2
200 mm*
100 mm
Weight of LCD assembly: 7.0 kg (MDview 232)
English-8
Figure S.1
100 mm
7.4 kg (MDview 241)
9.6 kg (MDview 271)
Figure F.1
Advertisement
Table of Contents
