TYAN S8050 Manual page 27

Table of Contents

The types of processors supported by the S8050 are listed in the 1.2 Hardware

Specifications section on page 4. Check our website at

the latest list of validated AMD

NOTE:

MiTAC is not liable for damage as a result of operating an

unsupported configuration.

Processor Installation (Single Socket / for AMD

Follow the steps below to install the processors and heat sinks.

Please note that the illustrations are based on socket which may not look exactly

like the motherboard you purchased. Therefore, the illustrations should be held for

your reference only.

NOTE:

Please save and replace the flip CPU protection cap when returning for

service.

Use a T20 Torx screwdriver to loosen the screws securing the force frame.

NOTE: The force frame will automatically eject after the captive screws are

being released.

By placing your both index fingers on the sides on the metal handle, pull to

release the rail frame. Then lift the rail frame to its fully open position.

Remove the external cap from the rail frame.

processors for this specific motherboard.

http://www.tyan.com

EPYC™ 9004 Series CPU)

for

Table of Contents