TP-Link AP200 User Manual page 8

Chapter 1
Name
(Power)
(Wireless 2.4GHz)
(Wireless 5GHz)
(LAN)
Slow blinking
Quick blinking
(WPS)
Note:
After a device is successfully added to the network by WPS function, the WPS LED will keep on for about 5 minutes
and then turn off.
LED Explanation
Status
On System initialization completes.
System initialization or firmware upgrade is in process. Do not
Blinking
disconnect or power off the AP device.
Power is off. Please ensure that the power adapter is connected
Off
correctly.
The wireless 2.4GHz band is working properly (in AP/Multi-SSID/
On
Repeater/Bridge mode).
The wireless 2.4GHz band is disabled (in AP/Multi-SSID/Repeater/
Bridge mode).
Off
The LED is always off (in Client mode).
The wireless 5GHz band is working properly (in AP/Multi-SSID/
On
Repeater/Bridge mode).
The wireless 5GHz band is disabled (in AP/Multi-SSID/Repeater/
Bridge mode).
Off
The LED is always off (in Client mode).
On A device is connected to the Ethernet port.
Off No device is connected to the Ethernet port.
WPS connection is in process.
On WPS connection is successful. It will turn off after 5 minutes.
WPS connection is failed.
Solid green The signal strength is great (in Repeater/Bridge/Client mode).
Solid orange The signal strength is good (in Repeater/Bridge/Client mode).
Solid red The signal strength is too weak (in Repeater/Bridge/Client mode).
The device is disconnected from the host network (in Repeater/
Off
Bridge/Client mode).
Indication
5