Table of Contents
Advertisement
Chapter 5
4. Enter the MAC address of the client device.
5. Enter the IP address to set to the client device.
6. Enter the Description of the client device.
7. Select the
Enable This Entry
checkbox.
8. Click OK.
The IP address reservation is configured successfully, and you can see the rule shown
as below.
5. 3.
Access Control
Access Control is used to allow or block specific client devices from accessing your
network. When a device is blocked, it is unable to connect to the Internet through your
network or communicate with other devices in the LAN.
To use Access Control, enable this function and specify a blacklist or whitelist. If Access
Control is disabled (Off ), all devices, including the blacklisted ones, are allowed to
access your network.
1. Visit http://tplinkap.net, and log in with the username and password you set for the
AP device.
27
Advertisement
Table of Contents
Need help?
Do you have a question about the AP200 and is the answer not in the manual?
Questions and answers