JNS Aquaria Sigma-1 Quick Start Manual

Maintenance
Regular maintenance of the pump will ensure long life and maximum performance: recommended every 3
months. You can disassemble the pump to clean by following steps:
Sigma-1
(1) Pull out the pump from the bottom. (2)
Separate the cover from the pump.
Sigma-2
on both side of the pump and pull out the cover. Take off the inside cover.
(1) Press the
PULL TO OPEN
(2) Pull out the inside parts
(Make sure to put back in position)
WARRANTY
JNS warrants all JNS products to be free from manufacturing defects for one year from the original purchase
date when purchased through an authorized JNS retailer. This warranty does not cover any damages caused
by misuse, neglect, alterations, or improper handling / transport / maintenance / installation. Physical damages
are not covered by the warranty. JNS does not cover personal injury, personal loss, or other damages
associated with the use of our products. In order to request warranty service, please email us at
info@jnsaquaria.com. A purchase receipt is required for any warranty service. Products requiring warranty
service must be returned to JNS. You are responsible for the cost of shipping a warranty claim to JNS and any
damages that may occur during transit. Once a returned product has been inspected, it will be repaired or
exchanged at our discretion and returned to you. International and/or expedited shipping are not covered
under your JNS warranty.
How to remove the limescale?
NO OTHER CHEMICALS, soak
in a mixture of 1 part water and
1 part vinegar (citrin acid also
Pull out the rotor.
available) for at least 24 hours.
Once you finish, please rinse
with warm water.
The rotor could be
disassembled.
Media Reactor
Sigma-1 / Sigma-2
Before installation and operation
Please open the package carefully and check if there's any damaged or lost parts.
Parts included:
Main media reactor body with Lid and base bracket
1
Filter sponge *2
2
Sicce Syncra pump *1
3
Sucker *3
3
1 2
Recommendations
1. While we take great care to keep any contaminants away from our products during
assembly, please take a moment to clean with warm water ONLY. Never clean Acrylic with
alcohol-based products. Use caution when handling acrylic scratches easily.
The reactor should be cleaned out every time that the media is replaced ensuring that there
2.
is no media below the bottom plate.
3. Regular maintenance of the pump will ensure a long life and maximum performance.
Select a suitable place to set your Sigma Media Reactor
Verify now that your sump has adequate space for the media reactor. Be sure that the
1.
media reactor can sit flat and that it is not touching the sides of the sump, any baffles or
any plumbing. This will ensure the quietest performance from your media reactor.
2. The pump must be completely submerged underwater when in use.
www.jnsaquaria.com
info@jnsaquaria.com
3 4