JNS Aquaria BS Series Installation Manual

BS Series Beckett Protein Skimmer
BS-2 / BS-3D / BS-5D
Please open the package carefully, and
check if there are any damaged or lost
parts. We should have:
A
B
F
C
D
E
G
Main body
A
( with silencers *2 / screws / O-ring )
B Collection cup ( with top lid / screws )
C Inlet tube set
D Drain port
E Air hoses *2
F Beckett set
G Drain tube fitting
Installation Guide
Collection cup: Loosen the screws to flip over the lid, then screws back.
1
(For safe shipping, the lid would be upside-down in the package.)
2
Check if O-ring is seal in the groove, and put on the collection cup.
Tighten the screws, but do not over-tighten, or product might be damaged.
4 5
Install the inlet set.
7 8
Use the thread seal tape (sold
separately) on the drain tube
fitting to prevent leaks.
Install the air hoses to connect the beckett set and silencers.
9
Install the drain tube fitting, and
connect your waste container to
waste tube of collection cup.
3
Install the beckett set.
6 Install the drain port, and turn it off.
Connect your pump to inlet tube.