Valor G3.5 700MN Installation Manual page 27

Installation
3. Place log G11 on the rear log support as shown,
behind the tabs. Slide it to the right until it presses
gently against the pilot shield.
4. Place the cover plate that came with the fi replace
into the depression in the platform in front of G4.
5. Place log G14 on top of G4 and into the platform
depression. It should rest against the inside of the
front edge of the depression.
6. Place log H18 on top of G14 and into the platform
depression. It should rest against the inside of the
front edge of the depression.
G11
G4
G14
G14
H18
7. Place H20 on top of H18 and G4 as shown. H20
rests on top of a knob on G4.
H20
G4
H18
8. Place embers in the depression in front of G4,
around the base of log H18 and G14.
G4
9. Place log G13 onto the right hand pin on G11 and
onto the platform as shown.
Fuel Beds
G11 G13
27