Table of Contents
Advertisement
E R R O R C O D E S
When power is applied, the unit will automatically enter a "Reset/Test" mode. This mode brings all
the internal motors to a home position. If there is an internal problem with one or more of the motors,
an error code will flash in the display, as described in the chart below. For example, when the display
shows "Pan" it means there is some type of error with the Pan motor. If there are multiple errors during
the start-up process, they will all flash in the display. For example: if the fixtures have errors on Pan, Tilt,
and Color Wheel 1 all at the same time, you will see the error message "Pan", "Tilt", and "Color Wheel
1" flash repeated 5 times.
If an error does occur during the initial start-up procedure, the fixture will self-generate a second reset
signal and try to realign all the motors and correct the errors. If the error persists after a second attempt,
a third attempt will be made. If after a third attempt all the errors have not been corrected, the fixture will
make the following determinations:
• 3 or More Errors: The fixture cannot function properly with three or more errors. Therefore the fixture
will place itself in a stand-by mode until subsequent repairs can be made.
• Less Than 3 Errors: The fixture has less than 3 errors. Therefore, most other functions will work
properly. The fixture will attempt to operate normally until the errors can be correct by a technician.
The errors in question will remain flashing in the display as a reminder of internal errors.
Error Code
Pan
Tilt
Color Wheel 1
Color Wheel 2
Focus
Zoom
Gobo
Rot Gobo
Prism 1
Prism 1 Rot
Prism 2
Prism 2 Rot
LED Fan
Base Fan
LED Temp
Base Temp
Description
Pan Error
Tilt Error
Color Wheel 1 Error
Color Wheel 2 Error
Focus Error
Zoom Error
Gobo Wheel Error
Gobo Rotation Error
Prism 1 Error
Prism 1 Rotation Error
Prism 2 Error
Prism 2 Rotation Error
LED Fan Error
Base Fan Error
LED Temperature Error
Base Temperature Error
35
Advertisement
Table of Contents
