Table of Contents
Advertisement
VIPA HMI
3
Deployment Touch Panel
3.1 Installation
Overview
Installation cutting
Installation
HB160 | TP | 62M-JIDR | en | 20-20
The Touch Panel is suitable for the installation in operating tables and control cabinet
fronts. The installation happens via the back. The Touch Panel is provided with a
patented integrated fixing technique that allows an easy connection with a simple screw-
driver.
Due to the fact that the Touch Panel has a plug connector for bus connection and voltage
supply, a fast and easy device change is possible.
For the installation into a operating tableau and control cabinet fronts, the Touch Panel
requires the following front plate cutting:
Touch Panel
62M-JIDR-...
The fixing technique is integrated in the casing of the Touch Panel and accessible via the
back. For the installation, a small slit screwdriver is required
1.
Push the operator panel [3] from the front side into the front panel cutting [1] until it
touches the panel with the seal [2].
2.
Now bolt the lever [5] clockwise with the screwdriver [4] until it rotates to the out-
side.
3.
Further screwing bolts the lever to the front panel until it holds this to the control
cabinet front.
Deployment Touch Panel
W x H in mm
311 x 249
Installation
19
Advertisement
Table of Contents
