Table of Contents
Advertisement
9 Manufacturer's information
9.1 Delivery
● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.
9.2 Transport
1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
9.3 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.
10 Electrical connection
Risk of electric shock!
▶ Risk of injury or death (if operating
voltage is higher than safe extra low
voltage).
▶ Adjustments are made with the actu-
ator cover removed.
▶ Electric shock can cause severe burns
and fatal injury.
Always disconnect the product from
●
power supply!
Therefore, have all work performed
●
only by qualified electricians.
Power supply varies dependent on the
●
design (see product label).
Do not bridge terminals!
●
For parallel connection of several actu-
●
ators, use the version with K-no. 6410.
With version AE (additional potential-
●
free limit switches), the plug connec-
tions must not be interchanged with
the power supply.
www.gemu-group.com
DANGER
CAUTION
Required for electrical connection:
Allen key size SW3
●
Small flat screw driver
●
1.
Disconnect the plant from power supply.
2.
Remove the protective caps 1.
3.
Unscrew cable entry 2.
4.
Undo screws 3.
5.
Do not lose the washers 4.
6.
Disassemble the cover of the actuator 5.
7.
Insert cable through cable entry 2.
Remove internal sealing ring if necessary.
8.
Connect cable (see chapter "Connection diagram 12 / 24
V" and chapter "Connection diagram 100 - 250 V").
9.
Put on cover of actuator 5.
10. Tighten cover 5.
11. Put on protective caps 1.
12. Screw down cable entry 2.
13 / 34
10 Electrical connection
NOTICE
GEMÜ 9428
Advertisement
Table of Contents
