Cleaning The Hob - Beko HIYG 64225 SXO User Manual

• Discolorations and stains on the glass
surface are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm water
and a soft cloth or sponge and dry them
with a dry cloth.
• Do not use hard metal scrapers and
abrasive cleaners. It may damage the
surfaces.
• Ensure that the joints of the components
of the appliance are not left as damp and
with detergent. Otherwise, corrosion may
occur on these joints.

Cleaning the hob

Cleaning the gas burners
1. Before cleaning the hob, remove pot
holders, burner caps and heads from the
hob.
2. Clean the surface of the hob as per the
recommendations included in the general
cleaning information according to the sur-
face type (enamelled, glass, inox, etc.).
3. Clean the burner chamber with a cloth
soaked in detergent or with non-
scratching, soft brush. Ensure that no
food remains are left.
4. Clean the spark plugs and thermal ele-
ments (in models with ignition and ther-
mal element) with a well squeezed cloth.
Then dry with a clean cloth. Pay attention
that the spark plug and the thermal ele-
ment are completely dry.
5. Clean the burner caps and heads with
detergent water after each operation and
then dry them.
6. For persistent stains, keep burner caps
and heads in detergent water or warm
soapy water at least for 15 minutes.
Clean with a non-metallic and non-
scratching brush.
7. You may use the Quick&Shine cleaning
agents for the oven interiors and grills,
used on enamelled surfaces and recom-
mended by the authorized service, espe-
cially for persistent stains on enamelled
burner caps.
8. Do not contact burner caps with aggres-
sive detergents such as oven interior cle-
aning agents, descalers while cleaning
them, this may cause discolouration.
9. Clean the pot holders with detergent
water and non-scratching, soft brush after
each operation and then dry them.
10. When the burner caps and pot holders
are used as wet, persistent lime stains
may occur as a result of the heat. Ensure
that it is dried before operation.
11. Place burner heads, caps and pot hol-
ders respectively.
12. When placing the pot holders, ensure
that they centre the burners.
23/EN