Cleaning The Hob; Cleaning The Control Panel - Beko HII64720QUF2T User Manual

• Do not wash any component of your ap-
pliance in a dishwasher unless otherwise
stated in the user's manual.
For the hobs:
• Acidic dirt such as milk, tomato paste
and oil may cause permanent stains on
the hobs and components of the hob
zones, clean any overflown fluids imme-
diately after cooling down the hob by
turning it off.
Inox - stainless surfaces
• Do not use acid or chlorine-containing
cleaning agents to clean stainless-inox
surfaces and handles.
• Stainless-inox surface may change col-
our in time. This is normal. After each op-
eration, clean with a detergent suitable
for the stainless or inox surface.
• Clean with a soft soapy cloth and liquid
(non-scratching) detergent suitable for
inox surfaces, taking care to wipe in one
direction.
• Remove lime, oil, starch, milk and protein
stains on the glass and inox surfaces im-
mediately without waiting. Stains may
rust under long periods of time.
• Cleaners sprayed/applied to the surface
should be cleaned immediately. Abrasive
cleaners left on the surface cause the
surface to turn white.
Glass surfaces
• When cleaning glass surfaces, do not use
hard metal scrapers and abrasive clean-
ing materials. They can damage the
glass surface.
• Clean the appliance using dishwashing
detergent, warm water and a microfiber
cloth specific for glass surfaces and dry
it with a dry microfiber cloth.
• If there is residual detergent after clean-
ing, wipe it with cold water and dry with a
clean and dry microfiber cloth. Residual
detergent may damage the glass surface
next time.
• Under no circumstances should the
dried-up residue on the glass surface be
cleaned off with serrated knives, wire
wool or similar scratching tools.
• You can remove the calcium stains (yel-
low stains) on the glass surface with the
commercially available descaling agent,
with a descaling agent such as vinegar or
lemon juice.
• If the surface is heavily soiled, apply the
cleaning agent on the stain with a sponge
and wait a long time for it to work prop-
erly. Then clean the glass surface with a
wet cloth.
• Discolorations and stains on the glass
surface are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm wa-
ter and a soft cloth or sponge and dry
them with a dry cloth.
• Do not use hard metal scrapers and ab-
rasive cleaners. They may damage the
surfaces.
• Ensure that the joints of the components
of the product are not left damp and with
detergent. Otherwise, corrosion may oc-
cur on these joints.

7.2 Cleaning the hob

Glass cooking surface
Follow the cleaning steps described for the
glass surfaces in the "General cleaning in-
formation" section for the cleaning of glass
cooking surface. You may complete your
cleaning as per the information below for
special cases.
• Sugar-based foods such as dark cream,
starch and syrup should be cleaned im-
mediately, without waiting for the surface
to cool. Otherwise, the glass cooking sur-
face may be permanently damaged.
• Do not use cleaning agents for cleaning
operations you perform while the hob is
hot, otherwise permanent stains may oc-
cur.

7.3 Cleaning the Control Panel

• When cleaning the panels with knob-con-
trol, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
EN / 25
EN
CS