Beko HIYG 64225 SXO User Manual page 15

Rooms that do not have openable doors
and/or windows that open directly to the
outer environment
If the room where the appliance is installed
does not have a door and/or a window that
opens directly to the outer environment,
other products shall be sought that defini-
tely provide a fixed nonadjustable and non-
closable ventilation opening which meets
the total minimum ventilation opening requi-
rements for the total gas consumption of
the appliance as indicated in the above
table.Also the appropriate building regulati-
ons advise should be followed.
Where a room or internal space contains
more than one gas appliance, additional
ventilation area shall be provided on top of
the requirement given in the table above.
Size of additional ventilation area shall be
appropriate to regulations of other gas
appliances.
There should also be a minimum clearance
of 10mm on the bottom edge of the door
that opens to the inner environment in the
room where the appliance is installed.You
must ensure that items such as carpets and
other floorcoverings etc., do not affect the
clearance when the door is closed.
The cooker may be located in a kitchen,
kitchen/diner or a bed-sitting room, but not
in a room containing a bath or a shower.
The cooker must not be installed in a bed-
siting room of less than 20m
Do not install this appliance in a room be-
low ground level unless it is open to ground
level on at least one side.
Electrical connection
Connect the product to a grounded out-
let/line protected by a fuse of suitable ca-
pacity as stated in the
"Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or
without a transformer. Our company shall
not be liable for any damages that will arise
due to using the product without a groun-
ding installation in accordance with the
local regulations.
.
3
DANGER:
The product must be connected to
the mains supply only by an authori-
sed and qualified person. The pro-
duct's warranty period starts only
after correct installation.
Manufacturer shall not be held res-
ponsible for damages arising from
procedures carried out by unauthori-
sed persons.
DANGER:
The power cable must not be clam-
ped, bent or trapped or come into
contact with hot parts of the product.
A damaged power cable must be
replaced by a qualified electrician.
Otherwise, there is risk of electric
shock, short circuit or fire!
• Connection must comply with national
regulations.
• The mains supply data must corres-
pond to the data specified on the type
label of the product. Type label is at the
rear housing of the product.
• Power cable of your product must
comply with the values in "Technical
specifications" table.
DANGER:
Before starting any work on the
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Power cable plug must be within
easy reach after installation (do not
route it above the hob).
Plug the power cable into the socket.
Gas connection
DANGER:
Product can be connected to gas
supply system only by an authorised
and qualified person or technician
with licence.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held res-
ponsible for damages arising from
procedures carried out by unauthori-
sed or unlicensed persons.
15/EN