Table of Contents
Advertisement
Connect Base Cables
Connect cables from left upright to the SIB.
NOTE: Prior to handling electronics or cables, the installer should touch the metal frame of the unit to discharge static
build up. This reduces the risk of damaging control electronics due to electrostatic discharge.
NOTE: Connect coax that is run through the uprights to the end of the coax that runs in front of the treadmill frame.
Connect E-Stop and Attach Upper Bridge Plastic
1. Make E-Stop connection prior to securing upper bridge plastic onto the bridge weldment.
NOTE: Align the bridge plastic to the foam arms before securing the bridge plastic to the bridge! Make sure there
is a consistent gap across the two sides of the machine.
Item
1
2
Cable, Console to Base Signal
Item
1
2
E-Stop Connector on E-Switch
3
E-Stop Connector (on base interface
4
M6 X 16 Phillips Pan Head Screw
Page 27 of 46
Description
Cable, Console Power
Description
Top Bridge Plastic
cable)
4 Nm (3 ft. lbs.)
Qty.
1
1
Qty
1
1
1
7
Advertisement
Table of Contents
