Table of Contents
Advertisement
UNPACKING
GENERAL
INSTALLATION (ALL
DRYERS)
Unpacking/General Installation (All Dryers)
Upon arrival of the equipment, any damage in shipment should be reported
to the carrier immediately.
Upon locating permanent location of a unit, care should be taken in
movement and placement of equipment.
See outline clearance diagrams for correct dimensions.
Remove all packing material such as: tape, manuals, skid, etc.
Leveling: Use spirit level on top of dryer. Adjust leveling bolts on dryer (see
adjustable leveling bolts in maintenance section).
Check voltage and amperes on rating plate before installing the dryer.
The construction of the dryers permits installation side-by-side to save space
or to provide a wall arrangement. Position dryer for the least amount of
exhaust piping and elbows, and allow free access to the rear of dryer for
future servicing of belts, pulleys and motors. Installation clearance from all
combustable material is 0" ceiling clearance, 0" rear clearance, and 0" side
clearance.
Before operating dryer, open basket door and remove blocking between
front panel and basket. Read the instruction tags, owner's manual, warnings,
etc.
IMPORTANT
Opening the clothes loading door deactivates the door switch
to shut off the motors, fan, gas, steam, or electric element. To
restart the dryer, close the door and press in the push to start
button.
IMPORTANT
This dryer is designed for a capacity maximum load.
Overloading it will result in long drying times and damp spots
on some clothes.
IMPORTANT
Maximum operating efficiency is dependent upon proper air
cIrculation. The lint screen must be kept cleaned daily to
insure proper air circulation throughout the dryer.
IMPORTANT
Provide adequate clearance for air opening into the combustion
chamber.
Page 8
Advertisement
Table of Contents
