Unpacking / General Installation - IPSO DR30 Owner's Manual

UNPACKING
GENERAL
INSTALLATION
(ALL DRYERS)
Unpacking/General Installation (All Dryers)
Upon arrival of the equipment, any damage in shipment should be
reported to the carrier immediately.
Upon locating permanent location of a unit, care should be
taken in movement and placement of equipment.
See outline clearance diagrams for correct dimensions.
Remove all packing material such as: tape, manuals, skid,
etc
Leveling: Use spirit level on top of dryer. Adjust leveling
bolts on dryer (see adjustable leveling bolts in maintenance
section).
Check voltage and amperes on rating plate before
installing the dryer.
The construction of the dryers permit installation side-by-side to save
space or to provide a wall arrangement. Position dryer for the least
amount of exhaust piping and elbows, and allow free access to the
rear of dryer for future servicing of belts, pulleys and motors. The
installation clearance from all combustable material is 0" ceiling
clearance for the first 4" (102 mm)from the front of the dryer. After
the first 4" (102 mm), the ceiling clearance required is 6" (153 mm).
The rear clearance required is 0", and the side clearance is 1"
(26 mm).
Before operating dryer, open basket door and remove
blocking between front panel and basket. Read the
instruction tags, owner's manual, warnings, etc.
IMPORTANT
Opening the clothes loading door deactivates the door switch
to shut off the motors, fan, gas, steam, or electric element. To
restart the dryer, close the door and press in the push to start
button.
IMPORTANT
This dryer is designed for a capacity maximum load.
Overloading it will result in long drying times and damp spots
on some clothes.
IMPORTANT
Maximum operating efficiency is dependent upon proper air
circulation. The lint screen must be kept clean daily to ensure
proper air circulation throughout the dryer.
IMPORTANT
Provide adequate clearance for air opening into the combustion
chamber.
Page 8