Assembly Instructions - Kobalt SC1802LW Manual

ASSEMBLY INSTRUCTIONS

!
WARNING: To avoid injury, do not connect this tile saw to a power source until it is completely
assembled and adjusted and you have read and understood the instruction manual.
UNPACKING YOUR TILE SAW
Carefully unpack the tile saw and all its parts, and compare against the list and illustration on pages
3 to 5. With the help of an assistant, place the saw on a secure surface and examine it carefully.
!
WARNING
● To avoid injury from unexpected starting or
electrical shock, do not plug the power cord into a
source of power during unpacking and assembly.
The cord must remain unplugged whenever you
are adjusting/assembling the tile saw.
●
If any part is missing or damaged, do not
attempt to assemble the tile saw, or plug in the
power cord until the missing or damaged part is
correctly replaced.
●
DO NOT use this product if any loose parts on
the Package Contents or Hardware Contents
sections are already assembled to your product
when you unpack it. Parts on this list are not
assembled to the product by the manufacturer
and require customer installation. Use of
a product that may have been improperly
assembled could result in serious injury.
If any parts are damaged or missing, please call
888-3Kobalt (888-356-2258) for assistance.
!
WARNING: Do not attempt to modify this tool
or create accessories for use with this tool. Any
such alteration or modification is misuse and
could result in a hazardous condition leading to
serious personal injury.
ASSEMBLING THE STAND (FIG. 1, 2) - BAG O
●
Insert the right support (H) into the left
support (G) above the cross bracket on
the left support. Use the two long bolts (ii), four
washers (gg), two anchor plates (jj & kk) and
two lock nuts (hh) to connect the two supports,
as shown to form an "X". (Fig. 1)
●
Tighten nuts (hh) with the adjustable wrench
and a 13 mm wrench.
NOTE: Do not overtighten, because doing so
will not allow the leg assembly to move.
● Flip the stand assembly upside down as shown
in Fig. 2.
●
Attach one support leg (F) into one of the stand
legs using the bolt (ff), the two washers (gg)
and the nut (hh), as shown. (Fig. 2)
●
Tighten using the adjustable wrench and a
13 mm wrench.
●
Repeat the above steps to install the other three
lower legs.
● When assembly is complete, flip the stand
upright as shown in Fig. 2.
1
hh
G
H
ii
2
15
jj
gg
kk
gg
gg
hh
gg
gg
ii
gg
hh
F
ff