Table of Contents
Advertisement
en Installation instructions
Electrically connecting an appliance without a
protective contact plug
Note: Only licensed specialists may connect the appli-
ance. Damage caused by incorrect connection is not
covered under the warranty.
An isolating switch must be integrated into the perman-
ent electrical installation according to the installation
regulations.
Identify the phase and neutral conductors in the
1.
socket.
The appliance may be damaged if it is not connec-
ted correctly.
Only connect the appliance to a mains voltage
2.
between 220 und 240 V.
Connect the wires of the mains power cable accord-
3.
ing to the colour coding:
Green/yellow = Conductor
‒
Blue = Neutral conductor
‒
Brown = Phase (external conductor)
‒
20.8 Installing the appliance
Slide the appliance and centre it.
1.
Do not kink the connection cable.
If necessary, use a tool to remove the cable guide.
2.
Open the oven door completely.
3.
Remove the cover.
4.
28
Screw the appliance tightly onto the unit.
5.
Put the protective cover on.
6.
Note: Never close the gap between the worktop and
the appliance using additional battens.
20.9 Removing the appliance
Disconnect the appliance from the power supply.
1.
Undo the fastening screws.
2.
Lift the appliance slightly and pull it out completely.
3.
Advertisement
Table of Contents
