Settings - Atag VA63211LTO User Manual

8
1)
Programme
P5
P6
P7
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity
of dishes can change the values.
Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com

SETTINGS

Programme selection mode and
user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
Settings available in the user mode:
• The level of water softener according to
the water hardness.
• Activation or deactivation of the
acoustic signal for the end of a
programme.
• Activation or deactivation of the rinse
aid dispenser to use the Multitab option
with or without the rinse aid.
• The level of rinse aid according to the
required dosage.
As the appliance stores the saved
settings, there is no need to configure
it before every cycle.
Water
(l)
10
4
9 - 10
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode
the following way:
Press and hold RESET until the appliance
is in programme selection mode.
How to enter user mode
Make sure the appliance is in programme
selection mode.
To enter the user mode, press and hold
simultaneously
indicators
display is blank.
The water softener
The water softener removes minerals from
the water supply, which would have a
Energy
(kWh)
0.9
0.1
1.0 - 1.2
and
, , and
Duration
(min)
30
14
219 - 229
until the
flash and the