Atag VA63211LTO User Manual page 10

10
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicators
off.
• The indicator
• The display shows the current
setting: e.g.
– The levels of rinse aid range
from 0A to 6A where level 0A
means rinse aid is not used.
2. Press repeatedly to change the
setting.
3. Press on/off to confirm the setting.
The rinse aid empty notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying to
refill rinse aid. If the drying results are
satisfactory while using multi-tablets only,
it is possible to deactivate the notification
for refilling rinse aid. However, for best
drying performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
It is possible to deactivate the rinse aid
dispenser, in this case the dispenser does
not release rinse aid only if the option
Multitab is activated.
If the rinse aid dispenser is deactivated
and the Multitab option is not selected, the
dispenser releases rinse aid.
The use of the option Multitab with the
rinse aid dispenser deactivated decreases
drying results satisfaction.
If the rinse aid dispenser is deactivated
and the Multitab option is selected, the
rinse aid indicator is always off.
, and are
continues to flash.
= level 4.
How to deactivate the rinse aid
empty notification
Make sure the appliance is in user mode.
1. Press .
• The indicators
off.
• The indicator
• The display shows the current
setting.
– = the rinse aid empty
notification is deactivated.
– = the rinse aid empty
notification is activated.
2. Press to change the setting.
3. Press on/off to confirm the setting.
Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to activate
it.
How to activate the acoustic
signal for the end of programme
Make sure the appliance is in user mode.
1. Press .
• The indicators
• The indicator
• The display shows the current
setting.
– = the acoustic signal is
deactivated.
– = the acoustic signal is
activated.
2. Press to change the setting.
3. Press on/off to confirm the setting.
, and are
still flashes.
, and are off.
still flashes.