Table of Contents
Advertisement
AXIS Q36 Dome Camera Series
Specifications
15 Casing open-detector
16 Camera unit
17 Dome casing
18 Weathershield
LED indicators
Note
The Status LED can be configured to flash while an event is active.
Status LED
Unlit
Green
Amber
Amber/Red
SD card slot
NOTICE
NO
NO
TICE
TICE
• Risk of damage to SD card. Don't use sharp tools, metal objects, or excessive force when inserting or removing the SD card.
Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Unmount the SD card from the device's web interface before removing it.
Don't remove the SD card while the product is running.
This device supports microSD/microSDHC/microSDXC cards.
For SD card recommendations, see axis.com.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.
Buttons
Control button
The control button is used for:
•
Resetting the product to factory default settings. See Reset to factory default settings on page 64.
•
Connecting to a one-click cloud connection (O3C) service over the internet. To connect, press and hold the button
for about 3 seconds until the status LED flashes green.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet Plus (PoE+).
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Flashes before startup if the temperature is below -20 °C and heating is required. The product
starts when it reaches operating temperature.
Steady during startup. Flashes during firmware upgrade or reset to factory default.
Flashes amber/red if network connection is unavailable or lost.
60
Advertisement
Table of Contents
