Related Manuals for JWA MYERS 76431
Summary of Contents for JWA MYERS 76431
- Page 1 ASSEMBLY INSTRUCTION MYERS BEDSIDE TABLE ITEM CODE 76431 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
-
Page 2: Before You Start
PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when li�ing. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instruc�ons carefully before beginning assembly. -
Page 3: Parts List
PARTS LIST... - Page 4 PARTS LIST ITEM QTY NO. ITEM 10PCS 18PCS 3x12mm 18PCS 20PCS 2PCS 4PCS 4PCS 3x16mm 4x30mm 4PCS 4PCS 4x35mm (DL) (DR) (CL) (CR) ITEM QTY NO. ITEM DRAWER LEFT 1 PC TOP PANEL 1 PC PANEL DRAWER RIGHT 1 PC 1 PC BOTTOM PANEL PANEL...
- Page 5 STEP 1: (CR) (CL) STEP 2:...
- Page 6 STEP 3: 10xA 10xB 12xC STEP 4:...
- Page 7 STEP 5: STEP 6:...
- Page 8 STEP 7: (DL) (DR) STEP 8:...
- Page 9 STEP 9： STEP 10:...
- Page 10 STEP 11:...
-
Page 11: Back Side
SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws. - Page 12 To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the MYERS 76431 and is the answer not in the manual?
Questions and answers