Page 1
ASSEMBLY INSTRUCTION MILLS 4 DRAWER SHOE CABINET ITEM CODE 74698 Imported by JWA Furniture Pty Ltd, Brisbane Qld, Australia. For any assistance with assembly or for missing parts please refer to your receipt...
PRE-ASSEMBLY PREPARATION Before you start: 1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2. Take care when lifting. Product should be assembled as near as possible to the point of use 3. Ensure that you have all required contents for complete assembly 4.
PARTS LIST M4x16 Ø15x12mm M6x40mm 8x30mm 1 pc 64pcs 28p cs 6pcs 28p cs 4pcs...
Page 6
STEP 1:Fix dowel (B) and cam pin (A) to panel (1) (2) (3) (4).
Page 7
STEP 2:Fix panel (6) to panel (2) with cam lock (C). STEP 3:Insert panel (3) (4) into the holes in the panel (2) (5) (6).
Page 8
STEP 4:Insert panel (1) into the holes in the panel (3) (4).
Page 9
STEP 5:Fix panel (1) (2) (5) (6) to panel (3) (4) with cam lock (C).
Page 10
STEP 6:Fix Plastic tipping bucket (W) to panel (7) (8) (9) with screw (V2).
Page 11
STEP 7: Put the plastic retention plug into the hole of the panel (3) (4) Fix Plastic tipping bucket (W) to panel (3) (4) with screw (V2).
Page 12
SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wa ll anchors. 2. Attach the second Mount i ng Plate to the furn i ture frame with the Short Screws.
Page 14
To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the MILLS 74698 and is the answer not in the manual?
Questions and answers