Table of Contents
Advertisement
13 Configure the alarm settings [Alarm]
[Image capture size]
Select the capture size of images to be transmitted to the FTP server, images to be attached to the alarm
E-mail, or images to be saved to the SD memory card.
SW598A
SC588A
When "2 mega pixel [16:9]" is selected for "Image capture mode"
1920x1080/640x360/320x180
When "1.3 mega pixel [16:9]" is selected for "Image capture mode"
1280x720/640x360/320x180
When "1.3 mega pixel [4:3]" is selected for "Image capture mode"
1280x960/VGA/QVGA
SW397B
SC387A
When "16:9" is selected for "Aspect ratio"
1280x720/640x360/320x180
When "4:3 (VGA)" is selected for "Aspect ratio"
1280x960/VGA/QVGA
When "4:3 (800x600)" is selected for "Aspect ratio"
1280x960/800x600/QVGA
•
Default: 640x360
Note
SW598A
SC588A
•
When "2 mega pixel [16:9]" is selected for "Image capture mode", "1920x1080" can only be used when
it is saved to the SD memory card.
[Image compression rate upon alarm detection]
Select "On" or "Off" to determine whether or not to change the image quality of "Quality1" (®page 86) upon
alarm detection.
•
On: Images will be transmitted with the image quality selected for "Image quality upon alarm detection".
•
Off: Does not change the image quality upon alarm detection.
•
Default: Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occurrence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
•
Default: 5 Normal
13.4 Configure the settings relating to H.264
recording [Alarm]
Click the [Alarm] tab on the "Alarm" page. (®page 47, page 49)
140
Operating Instructions
Advertisement
Table of Contents
