Table of Contents
Advertisement
11 Configure the settings relating to images and audio [Image/Audio]
4.
Click the [End] button after completing masking areas.
→
The borders on the image displayed on the [Image/Position] tab will disappear.
IMPORTANT
•
The mask area may move out of alignment when the JPEG/H.264 "Image capture mode" or "Aspect
ratio" setting is changed. Make sure to check the setting after changing the "Image capture mode"
setting.
•
The mask area may move out of alignment when "Extra optical zoom" is configured. Make sure to
check the setting after changing the "Extra optical zoom" setting.
Note
•
When the [Reset] button is clicked, masking for all the masked areas will be canceled.
11.6.3 Configure the settings relating to the preset positions
("Preset position" setup menu)
Click the [Setup>>] button of "Preset position" on the [Image/Position] tab of the "Image/Audio" page
(®page 99).
It is possible to register, edit and delete the preset positions on this page.
When the focus, brightness, zoom factor are adjusted, the adjustment will be applied immediately to the
currently displayed image on the [Image/Position] tab.
110
Operating Instructions
Advertisement
Table of Contents
