Table of Contents
Advertisement
11 Configure the settings relating to images and audio [Image/Audio]
[Close] button
Click this button to close the "Direction setting" setup menu.
11.6.8 Configure the settings relating to the privacy zone ("Privacy
zone" setup menu)
Click the [Setup>>] button of "Privacy zone" on the [Image/Position] tab of the "Image/Audio" page
(®page 99).
When there is a zone that you do not want to display, set the zone as a privacy zone not to be displayed.
According to the setting of "Number of Privacy zone", up to 8 or 32 privacy zones can be set. (®page 95)
You can set the areas by dragging the mouse on the screen.
Note
•
The privacy zone function does not work when the camera is in the process of warming-up just after
turning on the power, or in the process of refreshing the position.
•
Depending on the panning/tilting direction (especially when the tilting degree is 45° - 90°) and the
zooming factor, the area set as the privacy zone may become visible. Make sure that each of the set
privacy zone is not visible after setting it.
Zone setting
[Zone select]
Click [
] of "Zone No" and select a zone number (1-8 or 1-32) from the pull-down menu.
An asterisk (*) next to the zone number indicates that the privacy zone has already been set for the number.
The privacy zone will be set when an area is designated by dragging the mouse.
Click the [Set] button after determining the position of the camera.
To delete the registered zone, click the [Delete] button after designating the desired zone number to be deleted.
Click the [Cancel] button to cancel what was set or deleted.
124
Operating Instructions
Advertisement
Table of Contents
