Table of Contents
Advertisement
⓬ Storing Changes for Lens Shift, Zoom, and Focus [LENS
MEMORY]
The adjusted values can be stored in projector memory when using the LENS SHIFT, ZOOM and FOCUS buttons
of the projector. Adjusted values can be applied to the signal you selected. This will eliminate the need to adjust lens
shift, focus, and zoom at the time of source selection. There are two ways to save adjusted values for lens shift,
zoom, and focus.
Function name
REF. LENS MEMORY
LENS MEMORY
NOTE:
• For using the lens unit NP16FL, NP17ZL, NP18ZL, NP19ZL, NP20ZL, NP21ZL, and NP31ZL, be sure to carry out [LENS CALIBRA-
TION] after replacing the lens unit. (→ page 18, 120)
• For the lens unit, NP16FL, the storable value as [LENS MEMORY] feature is for [FOCUS] only.
• The [LENS MEMORY] feature is not available for the lens unit, NP39ML.
Description
Adjusted values common to all input signals. At the time of installation,
two kinds of adjusted values can be stored.
If no adjusted values are stored in [LENS MEMORY], adjusted values
from the selected profile ([REF. LENS MEMORY]) will be applied for
lens adjustment.
Adjusted values for each input signal.
Use the adjusted values for the signal with a different aspect ratio or
resolution. The adjusted values can be applied at the time of source
selection.
60
3. Convenient Features
page
→ page 120
→ page 103
Advertisement
Table of Contents
