Table of Contents
Advertisement
2. Projecting an Image (Basic Operation)
❻ Optimizing Computer Signal Automatically
Adjusting the Image Using Auto Adjust
When an image from HDMI IN, DisplayPort IN, BNC IN terminal (analog RGB), COMPUTER IN, or HDBaseT is being
projected, and the edge is cut off or the image quality is poor, this button can be used to automatically optimize the
projection image on the screen.
Press the AUTO ADJ. button to optimize a computer image automatically.
[Poor picture]
[Adjusted picture]
NOTE:
Some signals may take time to display or may not be displayed correctly.
• If the Auto Adjust operation cannot optimize the computer signal, try to adjust [HORIZONTAL], [VERTICAL], [CLOCK], and [PHASE]
manually. (→ page 96, 97)
• If you can not obtain an optimized picture, refer page 182.
33
Advertisement
Table of Contents
