Table of Contents
Advertisement
192.168.1.X, X is any integer from 2 to 253, and the address is not used. The subnet mask can be
used by default. Click "Next" when finished.
Step 3 Go to the "Wireless" page. The device can modify the wireless parameters such as network
name, frequency, and key through this page. The default wireless mode of the device is the Station.
The default network name of the device is Wireless. When pairing with the Access Point device,
please note that the key and the SSID on the Station side must be the same as the Access Point.
Other configurations are recommended to keep the default values. Click "Next".
Step 4 Go to the Setup "Wizard – Finish" page and click "Change" to save the configuration.
Users can also click the "Wireless" bar at the top of the page to enter the "Wireless" page and
modify the network name, frequency, key and other parameters.
DS-3WF03C Quick Start Guide
Figure 4-2 Wizard – Network
Figure 4-3 Wizard – Wireless
Figure 4-4 Wizard – Finish
13
Advertisement
Table of Contents
