Table of Contents
Advertisement
Figure 23. Remove the one screw and remove the I/O bracket.
Screw specifications
M2 x L2
Go to
https://support.lenovo.com/partslookup
part:
I/O bracket
Remove the USB board module
Make sure the following FRUs (or CRUs) have been removed.
"Remove the LCD module" on page 28
"Remove the battery pack" on page 32
"Remove the I/O bracket" on page 38
Step 1.
Peel off the three pieces of tape.
Figure 24. Peel off the three pieces of tape.
Step 2.
Disconnect the USB board cable from the system board. Remove two screws and then remove the
USB board module.
Number of screws
1
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
39
Advertisement
Table of Contents
