Turning The Camera On/Off - Ikelite 69121 Manual

3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4. Place each lid snap into the corresponding hook on the housing
back.
5. Push the lid snaps towards the housing until they are flat against
the housing and the lock has engaged. Close both lid snaps at the
same time.
6. Check the o-ring seal. The o-ring should form a uniform, solid line
visible through the back of the housing.
7. Check control functions.

Turning the Camera On/Off

1. The housing on/off lever acts like your finger pressing against
the side of the camera's control. Rotate the knob to operate the
control. The control will only operate in one direction depending on
which side of the camera's control the lever is sitting on.
2. To reverse directions, lift and rotate the knob to move the lever to
the other side of the control.
If the control knob stops and the desired effect hasn't
»
occurred, repeat step 2 to reverse directions.
13