Setting Up An External Strobe; Getting In The Water; Final Check - Ikelite 69121 Manual

The port must be fully seated onto the housing for waterproof
»
operation. There should only be a very thin, even gap of
approximately 0.15" (4mm) between the bottom of the port and
the front of the housing.

Setting Up An External Strobe

We recommend attaching an external strobe for the optimal color and
clarity in a wide variety of photographic situations, including daylight
photography.
External strobe triggering is supported by the following options (sold
separately):
•
B1A Bulkhead # 46002 + Manual Flash Hotshoe # 46071 for
manual flash exposure with compatible strobes
•
DL2 DS Link TTL Converter Kit ST1 Hotshoe B1A Bulkhead Kit #
46045 for TTL flash exposure with compatible Ikelite DS Strobes
•
Manual Fiber Optic Trigger # 44700 + Manual Flash Hotshoe #
46071 for manual flash exposure with compatible strobes

Getting in the Water

Final Check

1. Re-check the rear o-ring seal. The seal should form an even, solid
line visible through the back of the housing.
2. Turn on the camera and check all control functions.
3. Make sure the camera can take a photo.
4. Check camera battery level and available storage space on your
memory card.
5. Draw a vacuum on the housing to check for leaks using the
optional vacuum kit, if using (sold separately).
17