Saving A New Tyre Pressure In The Monitoring System - Volvo V60 TWIN ENGINE 2019 Owner's Manual

WHEELS AND TYRES
||
not work correctly due to the differences
between the wheels.
The system does not replace the need for
•
regular tyre inspection and maintenance.
It is not possible to switch off the tyre
•
pressure monitoring system.
WARNING
Incorrect tyre pressure may lead to tyre
•
failure, which could result in the driver
losing control of the car.
The system cannot indicate sudden
•
tyre damage in advance.
Related information
Recommended tyre pressure (p. 572)
•
See tyre pressure status in the centre dis-
•
play* (p. 575)
Action in the event of warning for low tyre
•
pressure (p. 576)
Saving a new tyre pressure in the monitor-
•
ing system* (p. 574)
Messages for tyre pressure monitoring*
•
(p. 577)
4 Indirect Tyre Pressure Monitoring System (ITPMS)
574
Saving a new tyre pressure in the
monitoring system*
In order for the system for tyre pressure
4
monitoring to work correctly, a reference
value for the tyre pressure must be saved.
This must take place every time the tyres are
changed or the tyre pressure is changed so
that the system can warn about low pressure
correctly.
For example, when driving with a heavy load
or at high speed above 160 km/h (100 mph),
the tyre pressure should be adjusted in
accordance with Volvo's recommended tyre
pressure values. The system is then reset by
saving a new tyre pressure.
Perform the following procedure to store a
new tyre pressure as a reference value in the
system:
1. Switch off the car.
2. Inflate the tyres to the correct pressure,
see the decal on the door pillar on the driv-
er's side showing the recommended pres-
sure for factory fitted tyres.
3. Start the car.
4. Open the Car Status
app in the app view.
5. Press TPMS .
NOTE
The car must be stationary for the
Pressure button to be selectable.
6. Press Store Pressure
.
7. Tap on OK to confirm that the tyre pres-
sure in all four tyres has been checked and
adjusted.
8. Drive the car until the new tyre pressure
has been saved. The new tyre pressure is
stored when the car is driven at a speed
above 35 km/h (22 mph).
> When sufficient data has been collec-
ted for the system to be able to detect
low tyre pressure, the animation show-
ing storage progress disappears from
the centre display. The system does not
provide additional confirmation that a
new tyre pressure has been saved.
If storing fails, a message is shown:
pressure unsuccessful. Try again.
* Option/accessory.
Store
Storing