Volvo V60 TWIN ENGINE 2019 Owner's Manual page 502

Hide thumbs Also See for V60 TWIN ENGINE 2019:
Table of Contents

Advertisement

STARTING AND DRIVING
||
sists of three programmable buttons and one
indicator lamp in the mirror glass.
For more information about HomeLink
www.HomeLink.com or call
00 8000 466 354 65 (or the toll number
+49 6838 907 277)
16
.
Save the original remote controls for future
programming (e.g. when changing to another
car or for use in another vehicle).
IMPORTANT
The programming for the buttons should
be deleted when the car is sold.
Related information
®
Using HomeLink
* (p. 502)
Programming HomeLink
Type approval for HomeLink
Applies to certain markets.
14
15
HomeLink and the HomeLink house symbol are registered trademarks of Gentex Corporation.
16
Note that the toll-free number may not be available depending on operator.
17
Applies to certain markets.
500
Programming HomeLink
Follow these instructions to program
®
HomeLink
, visit
gram individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position"
before HomeLink
used. If possible, fit new batteries in the
remote control that shall be replaced by
HomeLink
improved transmission of the radio signal.
The HomeLink
before programming.
WARNING
®
While programming HomeLink
* (p. 500)
garage door or gate being programmed
®
* (p. 503)
may activate. For this reason, make sure
that nobody is in the vicinity of the door or
gate while programming is in progress. The
car should be outside the garage while a
garage door opener is being programmed.
®
17
*
®
, reset all programming or repro-
®
can be programmed or
®
for faster programming and
®
buttons should be reset
®
, the
1.
Aim the remote control towards the
®
HomeLink
button to be programmed and
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indi-
®
cator lamp on HomeLink
.
Note: The ability of some remote controls
®
to program HomeLink
is improved at a
distance of approx. 15-20 cm (approx.
6-12 inches). Bear this in mind if problems
occur with the programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
* Option/accessory.
®
.

Advertisement

Table of Contents
loading

Table of Contents