Uncertainty for the sound power level (K
Peak sound pressure emission level (L
Uncertainty for the peak sound pressure level (K
4.3 Vibration
The vibration value that must be specified in accordance with 2006/42/EC does not exceed 2,5 m/s².
5 Operation
5.1 Preparations at the workplace
5.1.1 Establishing the position of the fasteners
To avoid incorrectly driven fasteners, proceed as follows:
▶ Each time you lay a metal sheet in position on the steel beams, use a water-resistant pen to mark the
area in which fasteners can be driven.
Note
Do this each time, for each individual metal sheet. It is not sufficient to simply mark the ends of
the beam and then draw a straight line between these points as the supporting beams may be
distorted, i.e. curved.
5.1.2 Checking that the tool is ready for use
Note
This check should always be carried out immediately before use of the fastening tool and after
reassembling the tool after cleaning or after a routine check of the condition of the piston and piston
brake.
1. Check the fastening tool for visible signs of damage,
especially to the components shown in the illustra-
tion.
Result
Visible signs of damage are found.
▶ Have the tool repaired by Hilti Service.
2. Make sure that there are no cartridge strips and no nail strips in the tool.
Printed: 28.06.2017 | Doc-Nr: PUB / 5359693 / 000 / 00
)
WA
)
pC, peak
)
pCpeak
Catch
@
Pressure pin
;
Slider and pivoting plate
=
Nosepiece
%
2 dB(A)
131 dB(C)
2 dB(C)
English
9