Table of Contents
Advertisement
2. Pull down the position adjustment handle.
3. Tilt the cutting attachment with the handle to the
applicable position.
4. Release the position adjustment handle to lock the
cutting attachment.
To adjust the length of the shaft
1. Release the knob.
2. Pull out the shaft to the applicable length.
1266 - 003 - 23.09.2022
3. Tighten the knob.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the speed of the cutting
equipment and gives the longest operation time from the
battery.
Note:
The SavE function does not decrease the
cutting power of the product.
1. Push the SavE button on the keypad to start the
function. The green LED comes on.
2. Push the SavE button again to stop the function. The
green LED goes out.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
45 seconds.
To set the product in transport position
WARNING:
when the product is in transport position.
1. Remove the battery from the product.
2. Install the transport guard on the cutting attachment.
3. Fold the cutting attachment 180° to make the cutting
attachment parallel to the shaft.
Do not start the product
13
Advertisement
Table of Contents
