Memory Tuning - Sangean ATS-909 User Manual

The Step button (5) is used to determine the tuning spread for each step of the Rotary Tuning Knob.
Spread may be changing accordingly:
FM
STEP
100 KHz
Fast
Slow 50 KHz
AUTO/MANUAL SCAN TUNING
To start Auto Scan Tuning select band to tune and press one of the tuning buttons (10) for more then 1/2
second. Once scan starts release button. The Auto Scan stops as soon as a station of adequate signal
strength is located. Repeat operation to start scan again. Scan can be halted by pressing the tuning
button (10) momentarily any time during the scanning process.
To manually tune to a frequency of your choice hold down one of the tuning buttons (10) until the
frequency desired is displayed.

MEMORY TUNING

It is possible to preset up to 306 stations using memory capability of the A TS-909. Each 9 presets
compromise 1 page. The SW band is capable of storing 29 pages or 261 preset stations (29 Pages x 9
Presets/Page): 18 Presets on FM and MW (2 Pages 9 Presets)and 9 presets on LW.
To Manually Set Memory on FM/MW/LW Bands:
Tune to station you would like to program into memory. Press memo button (16) [M], MEMO will flash in
LCD display, select page desired by pressing PAGE button[11].Display will flash and next available
position on display will flash if an available. If memory is memory is full no suggested position
will flash and LCD will display MEMOFULL when any button is depressed. Press
new frequency to available flashing open position, If selected button is held for more then 2 seconds,
even with MEMOFULL flashing, newly selected station will replace existing station.
To Manually Set Memory on SW Bands:
Tune to station you would like to program into memory. Press memo button (16)[M], MEMO will flash in
LCD display. Select page desired by using UP/DOWN button [10]. Display will flash and next available
position on display will flash if an available position is available. Press
to flashing available position. If memory is full no suggested position will flash and LCD will display
MEMOFULL when any button is depressed. If selected button is held for more then 2 seconds, even
with MEMOFULL flashing , newly selected station will replace existing station.
You may change or initiate any page name at any time by first selecting the page and then pressing
the edit button (12)[EDIT] and using the Rotary Knob(31) to place an alphanumeric character in the name
BANDS
LW MW
9 KHz
9/10 KHz
1 KHz 1 KHz
8
AM
SW
USB/LSB
5 KHz
1 KHz
1 KHz
40 Hz
( ) button to assign frequency
( )
button to assign