Upflow Model Installed Vertically; Drain Exiting Right Side; Drain Exiting Left Side - Amana MVM97 Installation Instructions Manual

#2
#1
#4
#7
#9
NOTE: Drain components shown
for information purposes only. For Horizontal Installa-
tions, a Horizontal Drain Kit may be needed. Refer to
the specification sheet for kit part number.

Upflow Model Installed Vertically

The trap and factory installed hoses remain as shipped.
The furnace drain may exit either the right or left side of
the furnace cabinet. Both sides of the cabinet have two
.875" diameter holes which can be used interchangeably
for drain and low voltage wiring purposes. If a higher
drain exit is needed, a .875" diameter hole may be added
in the area shown in Figure 22. Any unused cabinet open-
ing must be sealed. Do not allow drain hose to sag or trap
water.
#5
#8
#10
100 Degree
#11 Elbow
Figure 21
Figure 22
45 degree
barb-pipe
adapter
Coupling

Drain Exiting Right Side

1. Locate and Install the 45º pipe / hose drain cou-
pling from the outside of the cabinet (barbed end goes in
the cabinet) through hole in the right side of the cabinet
and secure with two field supplied #8 self-tapping screws
(see Figure 23).
2. Locate the long drain hose #3 and cut at line "A"
.
3. Install large end of hose #3 to trap outlet and
secure with 1.25" clamp.
4. Install smaller end of hose #3 on 45º elbow and
secure with 1" clamp.
5. Refer to Field Supplied Drain section for instruc-
tions on field supplied / installed drain on outlet of fur-
nace trap.

Drain Exiting Left Side

1. Install the 45 degree pipe / hose drain coupling
from the outside of the cabinet (barbed end goes in the
cabinet) through the hole in the left side of the cabinet
and secure with two field supplied #8 self-tapping screws.
(see Figure 23).
2. Locate the long drain hose #3 and cut at "B" line
for a 17.5" cabinet; cut at line "C" for a 21" cabinet; do
not cut for a "D" width cabinet.
3. Install large end of hose #3 to trap outlet and
secure with 1.25" clamp.
4. Install smaller end of hose #3 on 45° elbow and
secure with 1" clamp.
5. Refer to Field Supplied Drain section for instruc-
Installer selects right or left side drain
and installs this hose accordingly.
Figure 23
Hose #1
Hose #2
45 degree
barb-pipe
adapter