Summary of Contents for onsemi FUSB15201DUAL60WGEVB
Page 1
Required Equipment: • Programmed FUSB15201DUAL60WGEVB • 14V DC power supply to power the FUSB15201DUAL60WGEVB • Cables with tinned leads to connect DC supply to the FUSB15201DUAL60WGEVB • FUSB302BGEVB and GUI • USB Type-C™ to USB Type-C™ cable 1. Connect the tinned cables from the 14V DC power supply to J4 of the FUSB15201DUAL60WGEVB.
Page 2
3. Start the FUSB302BGEVB GUI on the PC being used. 4. Attach the FUSB302BGEVB to one of the 2 USB Type-C ports on the FUSB15201DUAL60WGEVB using the USB Type-C to Type-C cable as shown. Figure 3 – FUSB302BGEVB attached to FUSB15201DUAL60WGEVB 5.
Page 3
FUSB15201DUAL60WGEVB and verify the FPDOs again. 8. If the FPDOs are listed properly for the 2 port, the FUSB15201DUAL60WGEVB is functioning properly and you are finished. If you encounter any problems, please contact onsemi support for the FUSB15201 product for further help. 5/31/2023 www.onsemi.com...