Table of Contents
Advertisement
Installation of Indoor Unit
Note: The insulating tube should be connected reliably with
the sleeve outside the outlet pipe. The drain hose should be
slanted downward slightly, without distortion, bulge or
fluctuation. Do not put the outlet in the water.
Connecting Indoor and Outdoor Electric Wires
1.Open the front panel.
2.Remove the wiring cover and wire clamp. Make the power connection cord pass through the hole
at the back of indoor unit.
3.Connect and fix the power connection cord to the terminal board. (As shown in Fig.6)
4.Fix the power connection cord with wire clamp and reinstall wiring cover.
5.Reinstall the front panel.
Wiring Cover
NOTE:
All wires between indoor and outdoor units must be connected by the qualified electric
contractor.
Electric wires must be connected correctly. Improper connection may cause malfunction.
●
Tighten the terminal screws tightly.
●
After tightening the screws, pull the wire slightly to confirm whether it's firm or not.
●
Make sure that the electric connections are earthed properly to prevent electric shock.
●
Make sure that all wiring connections are secure and the cover plates are reinstalled
●
properly. Poor installation may cause fire or
yellow-
brown
green
outdoor unit connection
electric
24
bulge
Fig.6
shock.
distortion
Flooded
Advertisement
Table of Contents
