Installation Of Indoor Unit - Sinclair ASH-24AIM PT User Manual

Installation of Indoor Unit

1. Mounting plate should be installed horizontally. As the water tray's outlet for the indoor unit is two-way
type, during installation, the indoor unit should slightly slant to water tray's outlet for smooth drainage of
condenser water.
2.Fix the mounting plate on the wall with screws.
3.Be sure that the mounting plate has been fixed firmly enough to withstand about 60 kg. Meanwhile, the
weight should be evenly shared by every screw.
18K unit：
24K unit：
1.Slant the piping hole (Ф55 or Ф70) on the wall slightly downward to the
outdoor side.
2.Insert the piping-hole sleeve into the hole to prevent the connection piping
and wiring from being damaged when passing through the hole.
Connect the drain hose to the outlet pipe of the indoor unit
1.
Bind the joint with rubber belt.
2.
Put the drain hose into insulating tube.
3. Wrap the insulating tube with wide rubber belt to prevent
the shift of insulating tube. Slant the drain
slightly for smooth drainage of condensing water.
Installation of Mounting Plate
55
694
17 82
189
684
Fig.5
145
Drill Piping Hole
Installation of Drain Hose
hose downward
23
196
160 123
145
120
Indoor
Wall pipe
.
outlet pipe of
indoor unit
rubber belt
outlet pipe of
indoor unit
outlet pipe of
indoor unit
Outdoor
Seal pad
Ф55
or
Ф70
outlet pipe of
indoor unit
drain hose
drain hose
rubber belt
insulating tube
rubber belt
insulating tube
connected