Table of Contents
Advertisement
Wireless Remote Controller (40VM900001) —
Indoor unit addressing can be performed using the wireless
remote controller. When using the wireless controller, the
user must maintain a line of sight with the receiver on the
indoor unit. See Fig. 44 for a description of the buttons on
the wireless remote.
AUTO
COOL
DRY
1 – MODE SETTING
HEAT
FAN
MODE
3 – ADJUST DOWN
5 – ON/OFF
7 – AIR VERT. SWING
SWING
8 – AIR HORIZ. SWING
SWING
RESET
LOCK C/H
12 – RESET
13 – LOCK
15 – COOL/HEAT
Fig. 44 —Wireless Remote Controller
(40VM900001)
Use a pin or a needle (or another small, sharp tool) to press and
hold LOCK for at least ten seconds, then press
Click
or
to select an address and press
setting. To display an indoor unit address, use the same tool to
press and hold LOCK for at least 10 seconds, and press
query the address.
Non-Programmable
Controller
When setting an address, connect only one wired controller to
an indoor unit.
Press ROOM TEMP and SWING simultaneously for three
seconds. If there is no address for this indoor unit, the display
shows FE# 00. See Fig. 45. Otherwise, the display shows the
current address of the indoor unit.
TEMP
SET
2 – FAN SPEED SETTING
CLOCK
SET
HOUR
FAN SPEED
4 – ADJUST UP
FAN
6 – AIR DIRECTION
9 – CLOCK SETTING
10 – TIMER ON
AIR DIRECTION
CLOCK
11 – TIMER OFF
TIMER ON
OK
TIMER OFF
14 – OK (CONFIRM)
to activate.
to send the
FAN
MODE
(40VM900002) —
MODE
ROOM TEMP.
FAN
Fig. 45 —Non-Programmable Controller
(40VM900002) IDU Addressing Menu
Click TEMP. UP or TEMP. DOWN to change 00 to the
desired address as shown in Fig. 46. Press OK to confirm, and
exit the setting interface.
to
MODE
ROOM TEMP.
FAN
Fig. 46 —Non-Programmable Controller
(40VM900002) Setting IDU Address
27
TEMP. UP
ON/OFF
TIMER
SWING
OK
TEMP. DOWN
TEMP. UP
ON/OFF
TIMER
SWING
OK
TEMP. DOWN
Advertisement
Table of Contents
